my st162 Now Boosting 5sgte

2 wheels done. New front wheel bearings also ordered.


Sent from my iPhone using Tapatalk

 

Not really that hard to be honest


Sent from my iPhone using Tapatalk

 

Well that's on way I simple just cut away the centre on the insides of the lights so the lights still have their support. I will change the whole front end later with frame. And then simply just for a bar long enough to go between and and bolt it up.
It took me some time befor I finally got the courage to even think about cutting it

Sent from my iPhone using Tapatalk

 

Yeah I would get rid of the headlights too if we didn't have twilight races lol. Yeah it's moving along well. Hope to get it to the track for a run in or just run it on the road in a few months


Sent from my iPhone using Tapatalk

 

Timing belt has arrived and been installed


Sent from my iPhone using Tapatalk

 

I've decided I would love my car even more if it was rwd




Sent from my iPhone using Tapatalk

 

Good news and bad news. Got the wheel bearings the other day. Got all set to getting them In today. Bad news both hubs have been spinning on the inner races so they are both fecked. Now I have to spend some time looking for new ones.


Sent from my iPhone using Tapatalk

 

So finaly got an N/A clutch plate today. Now I'm just waiting for my gt4 pressure plate to get here



Also got some new back pads as well for when they are needed. Will get some new rotors eventually.


Gaskets turn up for the cam covers intake and exhaust next week. Then hopefully clutch next week and it can finaly go in the car.

Then all that will be left is a few rose joints for the sway bar and tie rod end and front hubs and it can be back in the ground and moving on its own. Then hopefully look at giving it a coat of paint


Sent from my iPhone using Tapatalk

 

Long time coming but the engine is complete minus the clutch pressure plate.





As of tonight



I am literally only waiting for the pressure plate and it can finally go in the car after 15 months of being out


Sent from my iPhone using Tapatalk

 

Finally






Sent from my iPhone using Tapatalk

 

Made some more progress








Sent from my iPhone using Tapatalk

 

Zorst time....




Oh and btw I've been also been a little busy with something else




Sent from my iPhone using Tapatalk

 

Got some of the wiring out of the way




Sent from my iPhone using Tapatalk

 

Ok so it may not seem like I've done much in the photo's but I'm very close to starting the car again. Most of the engine is ready just have to change a couple of fittings on the intake manifold. Need some oil and filters. Just waiting on my hubs to turn up. Then the drive shafts can go in oil can go in wheels can go on and car can finally sit on the ground


Sent from my iPhone using Tapatalk