"the dog" grille filler

Discussion in 'Your 4th Gen beauty' started by jwagner162, Dec 16, 2010.

  1. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: Re: project "what the hell did i do?" motor and tranny

    yep trim is like that. and is original to the car. ?

    -springs are eibach drops so should be good. t-stat is new and good and timing is dead on.
    -im thinking its something fuel related, either a pump, fpr, or csi system issue. runs good but is getting tough to start. ign system is all new aswell. pulled the covers off today and the inside of the head looks great, everything has oil and is very clean. gonna re-check torque tomorrow, and install the nicer set of covers i have. then ill start on the fuel system and tvis checks.
     
  2. eNtraxGT88

    eNtraxGT88 Well-Known Member Donated!

    Re: Re: project "what the hell did i do?" motor and tranny

    original for all GT/ST that I've seen here
     
  3. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: Re: project "what the hell did i do?" motor and tranny

    thats what i thought. i guess im confused as to why the gt-s has it. no mount holes for the normal trim either.

    -heat wrap showed up so mani should be fitted tomorrow. and all new suspension stuff sould be here by sat. :mrgreen
     
  4. Stig

    Stig ST162 Guru Donated!

    Re: project "what the hell did i do?" motor and tranny in

    Im looking for a RHS front mudflap for one if you see any, I had to drill extra holes for those skirts but the mudflap
    was badly rusted inside

    Found any problems yet?
     
  5. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: project "what the hell did i do?" koni's IN!

    -see here
    viewtopic.php?f=50&t=7425

    -i havent driven it yet as im still need to wrap and install the new mani. but should be done tomorrow. i removed the old heat shield brackets and gave it a high temp copper coating before the wrap so i dont have clean steel waiting to rust underneath everything. tomorrow ill wrap and recoat the wrap. hopefully ill have enough time to drop it at midas to have the connection done. pic is before coating, ill be sure to grab some more.

    -[​IMG]
     
  6. 187flatliner

    187flatliner Seat Breaker Donated!

    Re: Re: project "what the hell did i do?" koni's IN!

    yes you have just the normal everyday side trim......
     
  7. 187flatliner

    187flatliner Seat Breaker Donated!

    Re: Re: project "what the hell did i do?" koni's IN!

    someone most likely traded out the gt-s skirts and put the regulars on....i did that with my gts......when i sold it tho i had custom skirts on it....and now he's selling those ones.......

    [​IMG]

    [​IMG]


    hes selling these ones for like 50 or 60 bucks. i liked them but the fitment needed alot of work. wish i would have just kept them and worked on them.....but they really did help sell the car i think.
     
  8. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: project "what the hell did i do?" koni's IN!

    -exhaust complete!

    -i know own the loudest 4cylinder within 25 miles. :byodood :byodood.

    -went and got an all new system. 2.25in. cat delete. so it has 1 small magnaflow resonator (maybe 8in) and a magnaflow straight through muffler. it looks great, and the idle is fantastic. it sounds like a v-8 idle. but at about 1500rpm the rasp comes in hard. this is really what i dreamed 09 would sound like, and i really like it on on ramps, but man its a bit too much for around town, i cant even keep it quiet w/o stalling.

    -i think ill have em add another resonator next week.

    -pics, and a vid this weekend. im off to work a late one tonight and will be sleeping all day tomorrow but ill get one i promise.
     
  9. celica_gt-i

    celica_gt-i Well-Known Member

    Re: Re: project "what the hell did i do to the exhaust?

    Waiting for that vid and pics :thumbsup:
     
  10. Mafix

    Mafix Owner Staff Member Administrator Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    just put a converter on it. it'll quiet it up nice.
     
  11. 187flatliner

    187flatliner Seat Breaker Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    i have the same set-up but with a cat......it nice.
     
  12. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: project "what the hell did i do to the exhaust?

    -i applied the high temp coating before and after the wrap since i did some grinding on it.
    [​IMG]
    -in car. im not super happy with the way i did the collectors (all in 1) but im about 3 ft short on wrap to make it right. it'll have to do since i aint coughing up the dough for another roll. added a universal 02 behind the collector, you can see the orange wire going to it. ill hide/rework it later.
    [​IMG]
    -muffler and tips.
    [​IMG]
    [​IMG]
    sometime this week i think im gonna swap the reasonator (8in) out for like a 30in one. i promise ill take a before vid though. its super uncomfortable to drive around worrying about getting pulled over for your insanely loud exhaust. i wouldnt mind if i wasnt going to make it a daily.
     
  13. Stig

    Stig ST162 Guru Donated!

    Re: project "what the hell did i do to the exhaust?

    Good are looks, I sense the force is strong with this one :cheers

    Liking the FE alt bracket, looks like you have a different bottle? alternator? wtf?
    [​IMG]

    Stocker looks like this, 2 resonators & rear twin silencer
    [​IMG]

    I ditched the cast iron lower mounts and use only the rear sump mount. those things
    are made from lead?

    I use a slightly bigger pipe (65mm) and a strait thru rear silencer with a 600mm resonator, it's loud with a boom around
    2000rpm and gets real raspy around 3-5000.
    ATM it's not enough for serious police attention but I want to add this Cat lookalike just to tone things down
    [​IMG]

    Some had real long resonators without the secondary, I think this was my old FE pipe?
    [​IMG]
     
  14. celica_gt-i

    celica_gt-i Well-Known Member

    Re: Re: project "what the hell did i do to the exhaust?

    Looks good :thumbsup:

    I wanna hear it :mrgreen
     
  15. 187flatliner

    187flatliner Seat Breaker Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    :iagree
     
  16. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    -ill go take a vid right now.

    -stig, the way the bracket is bent it should sit to the inside of the alt mount....atleast on mine. so i think there both the same just different mounting.
     
  17. jwagner162

    jwagner162 Well-Known Member Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    -ok so since ive been driving it ive had a hard start issue. cranks great, just takes 10 or 20 cranks and was getting worse. the filter is brand new and the injectors are freshly remanned, so i knew it wasnt those. borrowed a fuel pressure test kit from auto-zone, and found out the fuel pressure regulator was stuck open or otherwise internally broken. good thing i have spares. :D
    -ive also narrowed down the fuel gauge to the gauge itself (i think) but dont feel like taking it apart today. i think i need atleast a month between interior disassemblys.

    -gonna go run it for a bit, im hoping the fpr helps with what has been a very very mild...hesitation....feels like its winding up through medium revs. the exhaust smells different now, not as rich. so i think it was just running rich.

    -also i think im gonna keep the exhaust the way it is. everyone keeps teeling me its not as loud as i think. so maybe just super loud in the car. been trying to get a video up but it keeps screwing up halfway through the upload. sounds really crappy on the video anyway, think its the mic, so i might try the ole ladys new camera as it records in stereo.
     
  18. Stig

    Stig ST162 Guru Donated!

    Re: project "what the hell did i do to the exhaust?

    Hope it helps
    What pressure was it at?

    Yeah, bought another bracket - I think someone bent the other one straight.
     
  19. rickstar22

    rickstar22 Well-Known Member Donated!

    Re: project "what the hell did i do to the exhaust?

    We had the same kind of problem with one of the Supra's here... It was only after it was warm... got to the point where the car had to cool all the way down again before it would start. Ended up the shim job done was off and over-shimmed a tad, it was not allowing the valves to open and close correctly, pretty much screwing up combustion and compression. Re-shimmed the cotton picking thing, and haven't had the problem since... It was a fresh rebuild also...They have the same shim setup...

    Just another observation and diagnosis to throw out there... :hsdance :hehe
     
  20. 187flatliner

    187flatliner Seat Breaker Donated!

    Re: Re: project "what the hell did i do to the exhaust?

    hey do you think that could be a problem in our celi's when they dont want to start?
     

Share This Page