ST162 Shift Cables Needed (88v6celi V6 Swap questions)

To anybody, I need replacement cables for the S53 transmission. If there is another way to get this done with the ST18x cables, please let me know, but my ST18x cables are too long and will not correctly move the levers.

Also, 88V6Celi, your PM is full, so here are questions I have about your V6 swap:

Do you have any parts left over from your V6 swap, or even from your pre-V6 3S-XX w/ S53 Transmission?

I am nearly done with a V6 swap but am needing a few more things to make my life easier and was hoping you might have a few left over.

What I have done so far is mate an S54 to a 1MZ, mount the engine in the car, fab up some exhaust and finished routing the fuel lines.

I am looking for:

• Anything wiring harness related. I have a complete 3S-FE Manual Wiring Harness, and a semi-complete 1MZ-FE Manual Camry wiring harness, however i neglected to actually load up the internal chassis wiring when i was pulling the 1MZ engine, so I was hoping you still have your internal connections and gauges set up.
• Your strut tower cross brace notched for the intake with the extra bar across the top.
• And finally (and most importantly, your old S53 Shift Cables. In-fact this is most important as one of ours is bent and I cannot seem to find a legit replacement anywhere. St18X's are 3/4 of an inch too long on both ends preventing me from getting in any gears but 3/4.

Thanks!

Now to those of you who are interested in this V6 Swap, ill make a new thread for it here shortly (photos included).