1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Wiper motor/linkage

Discussion in 'Diagnosis/Help' started by scottjackson1209, Apr 13, 2015.

  1. scottjackson1209

    scottjackson1209 Well-Known Member Donated!

    Hey guys I need a hand. hopefully I can get a quick response so I can drive my car to work tonight. I pulled my wiper motor out and I'm having a hard time getting it back in. I was going to take the nut off the linkage on the motor but the joint popped out while I was trying to get it out. now I can't get the joint put back together. is there any easy way to access this part of the linkage?
  2. ST165-2765

    ST165-2765 Well-Known Member Donated!

    you can try removing the plastic vents above the firewall you may be able to get it back on with a long prybar...other than that your left with the round hole the motor fits into, you might try powering the motor and rotating the linkage to a different angle so you can snap the 2 pieces back together

    I have been able to snap the 2 pieces back together using the round motor mounting hole but it is a challenge

Share This Page