1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

power window problem!!!

Discussion in 'Electronics' started by DIASISS, Apr 15, 2009.


    DIASISS Guest

    can anyone tell me where the power window relay is for the passenger side??? :D
  2. Celic_GT2

    Celic_GT2 Well-Known Member Moderator Donated!

    both should run off either a fuse or a circuit breaker on the drivers side behind the kick panel..

    DIASISS Guest

    hmmm...but the drivers side window works fine...any suggestions... :D
  4. Rick89GTS

    Rick89GTS Well-Known Member Moderator Donated!

    If the pax window doesn't work, but can be controlled by the driver's side master switch, check the pax switch itself. Replace switch or clean the contacts.

    DIASISS Guest

    so if the master passenger switch doesnt work does that mean that the passenger window switch wont work {even if there is nothing wrong with it} :?:????
  6. Rick89GTS

    Rick89GTS Well-Known Member Moderator Donated!

    ^No, if master switch is not working, the pax switch should still work, that is, unless the whole circuit is fubared.

    Another thing it could be is the power window motor itself.
    After removing the interior door panel, unplug the wiring to the power window motor. It'll be a 2-pronged plug. Now take 2 leads from a 12V battery and run them to the two prongs (doesn't matter which side to which). The window should go up or down. If it does, you know the motor's ok and it's most likely the switch or wiring. Reverse the leads and test both ways for up and down.

    From __Scott__ at http://www.alltrac.net:

    Another helpful link (make sure the pax window lock is not "ON"!):
    http://alltrac.net/phpBB2/viewtopic.php ... wer+window

    DIASISS Guest

    thanks a lot Rick!!! ill look into it!... :D

Share This Page