Thanks. I'm having a difficult time trying to remove the Rear View Mirror Assembly. I'm trying to replace the front windshield weatherstripping, so I need to do this. I have pictures below. Q1. How do you remove the Rear View Mirror and Lamp Assembly? Screws? Clips? Q2. I see a screw inside towards the middle, but it's difficult (almost impossible) to get a good angle and unscrew it (see Pic02 and Pic03). Doe I need to get that screw? Q4. I printed some scanned instructions found on this website. Thanks to whoever did this. However, on some pictures I have difficulty seeing the detail. Have these instructions been re-scanned and uploaded? ) Q5. This is a question regarding something else, but hopefully more simple. I painted the Windshield Outer Moldings and the Rear Convertible Trim Moldings which curve around where the convertible top folds down. Novice question, but do these parts need a clear coat? I ask, because I was hoping these parts to be flat black, or the least amount of gloss possible. Thanks again. Pic01 - Angle from Gear Shift, towards front by breckjensen, on Flickr Pic02 - Angle from dash board, towards rear by breckjensen, on Flickr Pic03 - Closer Angle from dash board, towards rear by breckjensen, on Flickr
Re: Celica Convertible Questions Regarding Front Windshield. Solved. There were seven clips around the Rear View Mirror and Lamp Assembly plastic molding panel. Three in front, four in back. Thanks.
Re: Celica Convertible Questions Regarding Front Windshield. Cool kep us posted on your progress- keep snapping hose pics- You can make a TuT after your done if you like ! :cool
Re: Celica Convertible Questions Regarding Front Windshield. When I had the conv roof replaced I simply painted them flat black via a can of quality paint. It lasted a year or so until the paint broke down and you could begin seeing flaws. Note; the car was not covered so it received plenty of sun and I should have brought it to a painter to spray it but I simply didn't. :roll