Separate names with a comma.
Aren't those 14"s??? I didn't think that the 4th gens ran on 13"...It was hard enough to find 205-60-14's for my GTS. Vicdat
Agree probably a head gasket... That was the first sign my 3sge had about a year ago... I waited a bit but it kept getting worse so finally I did...
High Idle Hi James, Mine did a similar thing after I did my HG (3SGE)...I had two small vac hoses switched by mistake. They went from the intake...
Rear Wing Yeah that looks hoooorible...leave it off Vicdat
Lucas Stop Leak I'm planning on trying the Lucas this weekend...been getting a couple minor leaks from the aftermarket rack for a short while....
Maybe you've found your calling...
Bet it was fun to watch...
Welcome back!!! Be sure to wear your goggles and other protective gear...
So you definitely checked the coil and it will deliver a spark when powered up directly from a battery?
I had a similar situation on my '87 GT-S recently that turned out to be a bad coil. I ended up getting one off of an old Camry at the boneyard for...
Maybe its the timing belt rubbing against the plastic cover. On my 3sge the upper motor mount was real close to the engine until I replaced it...
In the future, if you can get it up on a lift it will be a little easier to get to everything from underneath ...especially if you have skinny...
Hey Spidy, I still think that the vacuum diaphragm on your TVIS is bad and that you probably have a small vac leak there. As I mentioned before...
Dirtbag dent That asswipe...I hate it when humanoids don't appreciate you shit...
Good job Spidey! It looks like your time and work paid off...I had a similar situation twice before, but the bad gasket wasn't so obvious. So the...
Flooding... Hi Spy, I occasionally get a similar issue. Also I'm pretty sure that my cold-start has never worked properly because every morning...
pre to post Yeah I just discovered the part about the different grilles the hard way...I found a pristine white 88 at the local boneyard...
Mine isn't ABS, and I don't think that Joe's '89 is either...
I just got a new set of Brembo (Stock type) front rotors and pads but upon inspection I discovered they were slightly different. If I get the cage...
After I replaced my oil pan gasket I'm still getting a little leak... Hope its not the rear main seal. (Maybe I didn't get the gasket on tight...