Separate names with a comma.
Also forgot to mention if anyone knows the Connecting Rod Bearing Mark 1 Bearing thickness? and Main Bearing Mark 3 Bearing Thickness?
Hi I currently have to motor out and apart. Would like to know what the oil clearance spec is for Main Bearings Mark 3, Also Connecting Rod...
Hey St165-2765, would you happen to have the Con-Rod specs too? The journal diameter and bearing measurements? Replacing the Con-Rod bearing at...
you can get a re-manufacted MAF at AutoZone here in the states
I have another question. With the motor off and the cams aligned to the crank and piston #1 up, what degree is the crank pointing at? 10 or 0...
Thank you for the reply. Do you know how the harmonic balencer should be when the motor if off? At 0 degrees or 10 degrees aligned with the cam?
Found this site with fault codes and how to pull them up on the diag. Box. Thought this might help anyone with the check engine light on like me....
Hi again. I set my timing back to stock, 10 degrees btdc. Now I got a check engine light come one:scratch I suspect it may be the o2 sensor but...
Thank you I will advance the crank timing to 10 degrees btdc
Hi anyone know timing degree spec while at idle? At the harmonic balencer aka crank pulley. I bought a Haynes service Manuel 86-89 my st162 spec...