1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Solid Poly Motor Mounts

Discussion in 'Aftermarket Modifications' started by slow_yota, Sep 20, 2007.

  1. slow_yota

    slow_yota Well-Known Member

    So i got my solid MM's in and i dont quite get how install these?
    Do i cut/burnout the old rubber mounts and then just press them new ones into place?
     
  2. CrazyAchmed

    CrazyAchmed Well-Known Member Donated!

    Are you talking about the poly solid mounts?
     
  3. slow_yota

    slow_yota Well-Known Member

  4. CrazyAchmed

    CrazyAchmed Well-Known Member Donated!

    I used a sawzall to cut the old mounts out of my DSM. Make sure you cut out the press ring too thats in the mount. Only took a couple minutes, and then I slid in the poly mounts.

    Using a vice makes life easier.
     
  5. slow_yota

    slow_yota Well-Known Member

    Should i put some type of adhesive inside them before i "squeeze" them in or will just press fitiing them in be good enough?
     
  6. Mafix

    Mafix Owner Staff Member Administrator Donated!

    nope
     
  7. CrazyAchmed

    CrazyAchmed Well-Known Member Donated!

    just press them in. Believe me. They are not coming out. Use a Vice. or a rubber mallet.
     
  8. Mafix

    Mafix Owner Staff Member Administrator Donated!

    or kick the shit out of them like we did.
     
  9. Letze

    Letze Well-Known Member

    LOL...

    Same kind of mounts that are in your GT-S willie? I wanna get some of those :p
     
  10. Mafix

    Mafix Owner Staff Member Administrator Donated!

Share This Page