Separate names with a comma.
I need a front clip, or just wiring harness essentially from a st165. Ideally it would be a front clip where the motor/trans has already been...
Lower cover for the 3S-GE engine. Attached to the engine, below the trans. The one you can take off to inspect the flywheel. Someone on here...
turned out to be a burnt fusible link, I read the schematic wrong and thought it was calling the AM1 and AM2 fuses fusible links...turns out the...
are they 2 or 3 pin? I'm looking at an aftermarket one on ebay to eliminate my flashing problem with led bulbs and I can't remember what mine...
Holy crap!!! What a tight job. cliffnotes: I wrote it and couldn't care less if you read it or not...now you just wasted a whole 2 seconds...
Can somebody go out and look at your engine and tell me which frost plug your block heater is installed in? my GE is right in the front behind...
flywheel interchange question. Looks like my dad is going to have to change the flywheel on his 88 camry....early 88 camry, with a 3S-FE. Now I...
I put the eibach prokit on last year...this spring imma need an alignment. Question is can I get away with just a 2 wheel alignment or will I...
I'm trying to get my bimmer goin and I need to try another intake tube. So I figured I have two at home from my celi so why not try those....
why is it that on my bmw there are two wires going to each windshield squirter? factory wires. I took them off to paint the car and am...
Two switches...two pop-up headlights.....any angle up or down....lights on or off ***********************DISCLAIMER****************************...
OK here goes. Some things can vary from my methods but this will give you a general indication of how its done Tools needed: drill various...
just wondering....I thought my 3S-GE was a non-interference engine Can anyone confirm or deny this?
my clutch...its happening more and more often now. Every couple shifts my pedal stays on the floor....it feels like it is getting caught on the...
just a couple teasers until I get it lowered [img] [img] [img] [img]
one off custom baby [img] [img] [img] [img] [img] [img] pics too if anyone is interested