Separate names with a comma.
Beams engine swap into st162 The good news is that the engine angle, engine mounts... Transmission drive shafts... All match up. The bad thing...
So it seems I will have to custom order Pistons for the Beams turbo build. I have an extra set of wiseco 86.5 forged Pistons to go along with the...
Beams swap into GT4 chassis and drivetrain Hey Resto! There is a guy in Sweden who has created a monster gt4 by using the beams head with VVT-i...
Hey guys it's been a while since I have been on here. A lot has changed, moved to Florida, bought a Saab (been modding that too). I have an 88...
Wiring Hey turbonelson420, check out tweaked performance.com. I talked with them about my wiring options. I am also doing the st215 into an 88...
Thread update So I got in touch with tweaked performance tuning. They offer custom patch harnesses for all toyota 4-cylinder engines. They can...
Harness and ecu options Thanks for the reply sillyca. So you had the 3sge harness and ecu hooked up on your build and had over fueling. I was...
Suggestions for ecu... Hey guys, the build project is moving onto the next phase which is engine management. I m curious to know if the st162...
Thread update Hey Mafix, yeah stock cams. I would like to install aftermarket cams and likewise aftermarket ecu. I know there is a lot of...
Thread update... So the no start issue was due to no compression. Cylinder one was registering 60, about one third what it should be. I pulled...
[ATTACH][ATTACH] Here you can see the layout of everything. I didn't want to go over the turbo exhaust housing with the compressed air but because...
Crank and no start on build Ok, so here is where it sits... cranks, but won't start. I bridged diagnostic terminals to see what code it throws...
thread update So... FMIC is installed and piping is done. What a fun way to spend the afternoon. I have my MAF sensor in line right before the...
thread update So I finally got my flywheel dustshield from Burien Toyota. I was chomping at the bit over Thanksgiving weekend waiting for that to...
quick update Quick update for you all. Finally have the engine rebuild finished and back in the engine bay awaiting wire harness and ignitor...
Hey guys, my motor is built and sitting on the engine stand waiting to get installed. I ordered a spec stage 3 clutch, and that is what I am...
Tranny There was a caldina engine-tranny up for sale on a US based JDMEngine Import company, but I havent seen it for a while. It was for 3sgte...
S54 bellousing around 3sgte pressure plate? So I am pretty sure I have seen this same question here on the forum, I may have even asked it...
You turbo setup Did you have any trouble fitting the turbo because of the starter? I plan on using a similar setup in my st162 coupe but have...
I will have to test the manifold out and post any clearance issues. I know it sits the turbo further out from the block, but I don't have exact...